Unplug lines – MTS Triaxial Cell Models 656-06 User Manual
Page 79
Description
Item
Tighten to 20 lb•ft (28 N•m)
2
Caution
:
Install the insert so the side with three holes faces out. If this side faces in, the insert’s
O-ring may leak.
6. Install the O-ring on the force transducer’s insert. Then use a nylon mallet to tap the insert in place.
Install the Insert
Description
Item
Holes must face out.
1
O-Ring
2
Tap in place.
3
7. Connect the force transducer’s cable to its feedthrough in the platen.
Unplug Lines
1. Remove the plug on the lower vent fitting. Install a vent hose on this fitting. Route the hose to a clean
5 gallon (20 litre) pail.
If you are going to use pore pressure in your test, unplug the two pore pressure ports.
Triaxial Cell Product Information | 79
Operation
This manual is related to the following products: