Metal Sales Clip-Loc Manual - Manual (Page 12)

PCL-12
CLIP-LOC
© Metal Sales Manufacturing Corporation/ Subject to change without notice/ Effective Date 9/11
800.406.7387 (Corporate Office) • www.metalsales.us.com
d
esign
/ i
nsTallaTion
C
onsideraTions
(
ConT
)
Steel roofing panels are subject to dimensional changes after installation due to exposure to varying temperatures. The greatest
influence is solar energy. Steel roofing absorbs various amounts of heat depending upon color, finish, angle of exposure, and
time of exposure.
The relationship of ambient temperature to building structural temperature must be considered when designing a Clip-Loc roof
system. The clips for the Clip-Loc panels are designed for expansion and contraction of the panels in the longitudinal direction.
Lateral expansion and contraction is accommodated by the configuration of the panel cross section and causes negligible panel
movement.
When the total length of panel run exceeds the capability of the clips to accommodate the thermal movement, expansion joints
must be designed into the structure.
SYSTEM EXPANSION / CONTRACTION
SELECTION OF SYSTEM COMPONENTS
The following chart should be used to determine proper fasteners required for clip installation on the selected applications (see
Fastener Selection Guide page PGI-12-14 for other fasteners available).
4 FASTENERS
4 FASTENERS
4 FASTENERS
2 FASTENERS
CLIP OVER RIGID
INSULATION /
METAL DECK
2 FASTENERS
4 FASTENERS
2 FASTENERS
STANDARD #10 X 1" PANCAKE HEAD DRILLER
#10 X 1" PANCAKE HEAD DRILLER
#10 X 1" PANCAKE HEAD DRILLER
#10 X 1" PANCAKE HEAD WOOD 4 FASTENERS
4 FASTENERS #10 X 1" PANCAKE HEAD WOOD
NUMBER
REQUIRED
TYPE OF FASTENER APPLICATION
STANDARD
INSTALLATION
REQUIREMENTS
24 GAUGE
26 GAUGE
26 GAUGE
24 GAUGE
**CLIP
SPACING
BY DESIGN
**5'-0" O.C.
BY DESIGN
**3'-0" O.C.
**5'-0" O.C.
STANDARD
#10 X 1" PANCAKE HEAD WOOD 22 GAUGE **3'-0" O.C.
CLIPS
OVER PURLINS
(16 GA. MIN)
CLIPS OVER
5 /
8
" WOOD DECK
DECK SCREW #14* 24 GAUGE
DECK SCREW #14* 26 GAUGE BY DESIGN
BY DESIGN
22 GAUGE BY DESIGN DECK SCREW #14*
STANDARD
STANDARD
STANDARD
STANDARD
STANDARD
STANDARD
22 GAUGE
Clip-Loc Clip
Clip-Loc Panel Clip - Clips are placed along the male leg of each panel prior to installing adjacent panels. Design wind uplift
must be considered for proper clip spacing.
* Length of Deck Screw will vary depending on the total thickness of the rigid insulation and metal (see page PGI-12).
** Based on UL 580. Subject to project loading requirements, closer clip spacing may be required. Contact your local
Metal Sales branch representative for more information (see pages PGI-2 and 3).