Lenze PC-based automation - Manual (Page 11)

DMS 1.3 EN - 02/2011
L
11
Control technology| System manual
Safety instructions
2 Safety instructions
Please observe the following safety instructions when you want to commission a controller
or system using the Industrial PC.

Read the documentation supplied with the system components thoroughly before
starting to commission the devices and the Industrial PC!
The system manual contains safety instructions which must be observed!

Danger!
According to our present level of knowledge it is not possible to ensure the abso-
lute freedom from errors of a software.
If necessary, systems with built-in controllers must be provided with additional
monitoring and protective equipment according to relevant safety regulations
(e.g. law on technical equipment, regulations for the prevention of accidents) so
that an impermissible operating status does not endanger persons or facilities.
During commissioning, persons must keep a safe distance from the motor or the
machine parts driven by the motor. Otherwise there would be a risk of injury by
the moving machine parts.

Stop!
If you change parameters in an engineering tool during an existing online con-
nection to a device, the changes are directly added to the device!
A wrong parameter setting can cause unpredictable motor movements. By unin-
tentional direction of rotation, too high speed or jerky operation, the driven ma-
chine parts may be damaged!