BenQ P51 - Manual (Page 25)

Startup 13
Startup
First-time startup
After you have installed the battery and finished charging it, you are ready to power ON your
PDA phone. The first time you power ON the phone, you will be guided through a series of
setup screens. Follow the steps below to start up your phone and complete the initial setup.
1. With the battery lock in the lock position, press Power to power ON the phone.
2. Wait for the phone to boot up with the BenQ-Siemens screen.
3. On the Windows Mobile screen, tap the stylus anywhere on the screen to proceed.
4. During the align screen process, aim and tap the stylus precisely on the cross-hair object. The
cross-hair object will move around the screen several times until the screen is aligned. Each
time the cross-hair object moves to a new location, aim and tap it.
5. Select the time zone of your location, and then tap Next .
6. The message shows you how the stylus works. You can single tap to select an item/command,
or tap and hold (long tap) for a menu (where available). Tap Next .
7. Tap and hold the 9 A.M. time slot to bring up a pop-up menu. Select Cut from the pop-up
menu.
8. Tap and hold the 11 A.M. time slot to bring up a pop-up menu. Select Paste from the pop-up
menu. Tap Next to continue.
9. Tap Next to enter a password if you want to protect access to your data and available networks
while using the PDA phone. If you do not need the password, tap Skip .
10. Tap anywhere on the final screen to exit setup.