Lenze PROFINET Controller-based Automation - Manual (Page 31)

Lenze · Controller-based Automation · PROFINET® Communication Manual · DMS 1.2 EN · 04/2014 · TD17
31
6 Commissioning of the PROFINET
6.2 The commissioning steps in detail
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.2.9 Configuring the I/O device
Set the IP address, subnet mask, gateway address and the station name of the I/O device in the PNIO
identification tab.
• Within the PROFINET network, the IP address of the I/O device has to be unambiguous.
• You do not have to set a baud rate as the I/O device automatically accepts the settings of the I/
O master.
6.2.10 Logging in on the controller with the »PLC Designer«
Use the menu command Online  Login or + to log in on the Lenze controller.
With the log-in, the I/O device configuration is loaded into the controller. In this process, a
configuration, if available, will be overwritten.