Lenze EZAEDE1000 - Manual (Page 25)

EZAEDE1000 DE/EN/FR/IT/ES 1.1 11
Operation 3
POWER LED
STATE LED Description State Description
Red Green NOTE: MMC = Memory Module Copier
m m Both Off No power
m Red: slow flash/3 sec; Green: Off MMC Off; Battery Charging - USB charger connected
m Red: Off; Green: slow flash/3 sec MMC Off: Battery Charged - USB charger connected
m Red: Off; Green On MMC On; Battery charged or Battery operation
Red: slow flash/3 sec; Green: On MMC On; Battery charging
Alternating: Red: flash; Green:
flash MMC On; Battery error: Battery over-charged or temperature
too high
Green: On 7 sec then 2 flashes
R & G MMC On, Low Battery Warning
MASTER LED
STATE LED Description State Description
Red Green
m m Both Off No memory module in the Master socket
m Red: Off; Green: On Memory module inserted in Master socket; Successful
Copy if Slave =
m Red: Off; Green: double flash
synchronized with Slave Copying in progress
m Red: On or double flashing; Green Off Copy operation failed. Refer to the error code table.
SLAVE LED
STATE LED Description State Description
Red Green
m m Both Off No memory module in the Slave socket
m Red: Off; Green: slow flash Memory module inserted in Slave socket
m Red: Off; Green: double flash synchronized
with Master Copying in progress
m Red: Off; Green On Last Copy operation finished successfully
m Red: On or double flashing; Green Off Copy operation failed. Refer to the error code table.
ERROR CODES
STATE LED Description Error Description
Red Green
m Steady Green No Error. Operation is successful
m Single blink Red Data incompatible
m Two blinks Red Memory module verification failed
m Three blinks Red Slave memory module different than master 1
m Four blinks Red Unknown module
m Five blinks Red Access to memory module failed/timeout
m Steady Red General access failure
1 For 9400 Series valid module combinations, refer to footnotes 1 and 2 in section 1, Introduction.