Lenze CS9800 Operating Instructions - Manual (Page 35)

Mechanical installation
Mounting steps
Fixing the mounting frame to the wall
5
l
35 BA_CSx8xx EN 3.0
With add−on component

1 0
‚
1 3
ƒ
„
6
4
5
2
1
4
0
4
CS57x0−006
How to proceed:
1. Check support arm system for professional mounting and sufficient carrying
capacity.
– See support arm documentation.
2. Stick the self−adhesive seal
0 on the adapter plate 1 on the side with the threaded
bolts.
3. Pull the connecting cables
2 out of the support arm 3 and screw the adapter plate 1
to the support arm
3.
– For screws see support arm documentation.
4. Screw the add−on component
4 to the threaded bolts of the adapter plate 1.
– 4 spacer bolts
5 on the inside/outside M5 x 20 mm
5. Stick the second self−adhesive seal
0 on the add−on component 4.
6. Screw the mounting frame
6 to the add−on component 4.
– 4 nuts M5 with washers
Æ 5.3 mm
– 4 screws M5 x 8 mm with washers
Æ 5.3 mm
Now you can connect the Command Station (
¶ 39).
5.2.3 Fixing the mounting frame to the wall
)
Note!
Before mounting:
ƒ Remove mounting frame (
¶ 33).
ƒ Read documentation of the accessories.
ƒ Check whether the mounting location corresponds to the operating
conditions described in the "Technical data"; if required, take additional
measures.