Landoll ICON AG-10 - Manual (Page 9)

General Operation
Each scraper operator has his/her own methods of hydraulic sequence and overall operation of the
machine. The following are suggestions as to the ICON Earthmover. Personal methods and choice of
tractors may alter these suggestions.
The ICON/Landoll machine is completely assembled and checked at the factory. It is requested of the
Dealer that after the first 24-36 hours of operation, the machine is then checked , and adjusted, if needed.
There are 24 zerks of the AG-10 that are marked grease daily, and 1 on each axle that are grease weekly.
Each bolt is torqued to proper specs at the factory, and after the initial 24 - 36 hours of running, should
be rechecked. All retaining pins have replaceable bushings. Watch the pin locations in action to review
for loose and worn operation.
Hydraulic hose configuration at the front of the machine is arranged to fit the late model remotes. Some
pulling units may require the relocation of the hydraulic hose configuration. A two-valve sequencing set-
up is standard. This allows the raise/lower to be controlled by valve #1, and gate/push-off by valve #2.
The operation of these valves is left to operator choice, for push/pull . This is controlled by the position
of the hoses at the tractor. On a two valve system, the timing of the loaded machine is critical to it’s
performance. It is important that the gate and push off wall work as they should. Adjustments to the
timing is made at the sequence block, located on the tongue of the machine. This setting is factory set,
but in time, can need re-adjustment. (Refer to the timing chart in the manual for instructions.)
A visual depth gauge is located at the right side, front of the machine. It allows the operator to set the
cutting edge to the proper depth for a smooth cut, or eject depth of the load. (It is marked in tenths of an
inch)
The ICON/Landoll Earthmovers have portions of the bowl painted with a carbon based, graphite paint,
which helps to reject dist. Should this paint wear off over a period of time, replacement paint may be
ordered thru the dealer.
Be patient for the first few hours of learning to operate the machine. Time and experience will produce
expert results. Any type of cutting edge machine will have the tendency to create a “washboard” effect, if
too much speed and inconsistent depth is used. Also, if the machine is used to “back level” or drag , be
certain that the gate is in the fully up position and the push off wall is completely forward. This allows
the operator to carry a small amount of material to fill with (if needed).
This machine is designed to be used with a pulling unit of 400 hp. maximum. Additional horsepower
will shorten the life of the unit and will alter the warranty. Responsible operation and proper maintenance
will provide many hours of expert results and a durable machine.
NOTE: This machine is not intended for highway use, it should be used off road only. If public roadway
travel is necessary, be certain of regulations concerning width, lighting, and safety requirements.
WARNING!
 Read and understand the operator’s manual before operating the machine. Allow no one to operate
the machine before reading the manual and being instructed on the proper operation.
 Before servicing the machine, block the wheels, shut the tractor off, set the brakes, and remove the
key. If working under the machine, block the machine up for a safe and secure working area. Apply
any and all safety stops provided.
 When working with hydraulic lines, cylinders, or fittings, wear protective clothing and safety glasses
to guard against high pressure oil leaks.
 Do not allow anyone on, or near the machine while it is running or in motion.
 Do not operate the machine on a steep incline or slope that could create an imbalance or rollover.