Landoll ICON AG-10 - Manual (Page 36)

________1. Install Cutting Bits, and Side Router Bits. Torque all mounting bolts.
________2. Install Lift Cylinder. Torque all pin retaining bolts.
________3. Position and pin Eject Wall. Install Eject Cylinder and Linkage. Torque all retaining bolts.
Install the depth gauge components.
________4. Locate and pin front gate and gate lift assembly. Install gate cylinders. Torque all retaining
bolts.
________5. Install front Dolly Hitch Assembly. Torque all pin retaining bolts.
________6. Install axle and wheel components. Torque all retaining bolts.
Inflate tires to required PSI.
________7. Locate and assemble all hydraulic fittings, hoses and blocks. Properly tighten fittings,
taking care not to overtighten. Install the proper markings to each hose and apply color
coded hose wrap.
________8. Install safety lighting components, route wiring and install plug retainer. Cycle and check
lighting system with 12 volt system tester.
________9. Lubricate all moving components with high temperature grease.
________10. Fill hydraulic system with Mobil 424 hydraulic oil. Using hydraulic pump, activate all
moving parts and bleed air from the system (if necessary). Hold 3000 PSI hydraulic
pressure against all cylinders, fittings, and hoses for a minimum of 4 minutes. Check all
components for leaks.
________11. Install all side covers and shields. Torque all retaining bolts.
________12. Clean and touch up paint the machine. Attach the manual container.
________13. Apply the serial tag, operations, lube and identification decals.
________14. Check function and proper engagement of all safety stops.
ICON Supervisor Signature: All of the above listed assembly and check functions have been completed
per my rigid standards.
Serial #______________________________ _________________________________________
checked by
Date:________________________________ _________________________________________
Supervisor
Customer Copy
AG - 10 Earthmover
Assembly, Lube and Check List