Troubleshooting guide – Landoll 876 Series Wing Tilloll User Manual
Page 57

TROUBLESHOOTING GUIDE
5-3
ROCKS JAMMING IN END OF REEL
AND LOCKING UP REEL
Reel blade too long
Cut 1-1/2" off the end of reel blade.
Reel angle wrong for terrain
Cut blade off at angle toward rear of blade
to provide a relief area for rocks.
HARROW PLUGGING
Improperly set harrow
Set according to operating instructions
(See “Harrow Adjustment” on
page 4-7.)
WINGS FOLDING TOO FAST
Restrictor elbows not installed
Check to make sure restrictors are
installed per assembly instructions.
Idle tractor when folding.
Turn tractor hydraulic flow down.
Engage hydraulic valve. Hold fully
engaged until folded.
MACHINE RUNNING DEEP TO ONE
SIDE
Distance from frame to axle of gauge
wheels differ
a. Set all depth stops the same.
b. Raise machine until all cylinders are
fully extended.
c. Measure cylinders from pin to pin.
Verify that all cylinders are same
length.
d. If measurements are not the same,
see “Hydraulic Lift Installation
(876-30, 876-35, 876-40-C)” on
page 3-9 and “Hydraulic Lift
Installation (876-40-H)” on page 3-11
to readjust cylinder length.
Wing cylinders may need to vary in length
from main cylinders, per soil conditions.
Check that tires are same size and
pressure is correct.
Check for hydraulic leakage and repair.
CYLINDERS BROKEN IN TRANSPORT
Machine not properly secured during
transport
Use transport locks and let machine down
on locks during transport (See
“Transport” on page 4-3.)
PROBLEM
PROBABLE CAUSE
SOLUTION