Landoll 876 Series Wing Tilloll User Manual
Model 876 series wing tilloll operator’s manual

F-143-0211
02/2011
LANDOLL CORPORATION
1900 North Street
Marysville, Kansas 66508
(785) 562-5381
Model 876 Series
Wing Tilloll
Operator’s Manual
Table of contents
Document Outline
- Introduction
- Standard Specifications
- Table 2-1: General Torque Specifications
- Table 2-2: Hydraulic Fitting Torque Specifications
- Figure 2-1: 876-30 Shank Placement Assembly (1 of 2)
- Figure 2-2: 876-30 Shank Placement Assembly (2 of 2)
- Figure 2-3: 876-35 Shank Placement Assembly (1 of 2)
- Figure 2-4: 876-35 Shank Placement Assembly (2 of 2)
- Figure 2-5: 876-40 Shank Placement Assembly (1 of 2)
- Figure 2-6: 876-40 Shank Placement Assembly (2 of 2)
- Assembly Instructions
- Figure 3-1: Frame Assembly
- Figure 3-2: Wing Assembly (876-30 & 876-35 Models)
- Figure 3-3: Wing and Extension Assembly (876-40 Model)
- Frame and Wing Assembly
- Shank, Clamp, and Sweep Assembly
- Gauge Wheel Installation
- Hydraulic Lift Installation (876-30, 876-35, 876-40-C)
- Hydraulic Lift Installation (876-40-H)
- Hydraulic Fold Installation - All Fold Models
- Disc Gang and Spray Shield Installation
- Reel Assembly Installation
- Harrow Assembly Installation
- Pull Hitch Installation - All Other Models
- Warning Lights Installation
- Lubrication
- Decal Placement
- Operation and Maintenance
- Troubleshooting Guide