Landoll D4P Power Ditcher - Manual (Page 12)

3-2 F-348-0411 Edition
ASSEMBLY INSTRUCTIONS
After Assembly - Safety

WARNING

CAUTION

CAUTION
General Assembly Instructions
1. The terms “right” and “left”, “front” and “rear”, refer to
the machine as viewed by facing in the direction of
forward travel.
2. Open all bundles. Do not mix parts of one bundle
with those of another. Place all bundles where they
will be easy to access.
3. Neatly arrange parts and tools within easy reach of
work area.
4. Use the correct grade of bolt in the proper locations
as indicated. Refer to the bolt torque chart for
descriptive markings on bolt heads.
5. After completing each assembly step, review next
step in procedure before proceeding with that step.
Assembly Instuctions
1. The D4P16A Power Ditcher is completely assembled
at the factory, except for the universal drive shaft
which is wired to the “A” frame.
2. Thoroughly clean the end of the drive shaft and
attach it to the input shaft of the ditcher with a 7/16" x
1" hex bolt, lock washer and special flat washer and
with two 5/16" x 1-3/4" grade 8 shear bolts and lock
nuts.
3. The power ditcher is now fully assembled and ready
for attachment to the tractor.
1. Be sure all nuts, bolts, other fasteners and
hydraulic fittings are properly tightened.
Refer to the bolt torque chart.
2. Be sure all safety guards and safety locking
devices are in place and function properly.
Before operating the machine, be sure to read the
safety and operation sections of the operator’s
manual.
Before delivering the machine, review machine
maintenance, operation and safety with the
customer.