Tires, Lubrication, Warning lubrication – Landoll PT Series 10 through 20 Transport Pulverizer User Manual
Page 38: Warning

4-2
9J017
PREVENTATIVE MAINTENANCE
Tires
The wheels furnished with 10’ - 12’ pulverizer models are
designed for use of 7.60 x 15, 6 ply rib implement tires.
The wheels furnished with 14’ - 20’ pulverizer models are
designed for use of 9.5L x 15, 6 ply rib implement tires.
The tires must be inflated to 28 psi.
NOTE
Use of smaller or lighter tires will cause premature tire
failure and may cause an accident.
Figure 4-1 Wheel Hub
WARNING
Lubrication
NOTE
It is good maintenance practice to check all bolts for
tightness during regular lubrications. Tighten any
fasteners that may have loosened during operations.
Your Brillion Pulverizer has been designed for a minimum
of daily lubrication. Grease the drawbar pivot pin once a
day when using the pulverizer. The roller axle sealed
bearings require no additional lubrication.
• Grease wheel hub zerk fittings every 50 hours of
Transport Operation.
• The transport wheels should have the wheel hub
removed and repacked annually before each season
usage.
WARNING
NOTE
Avoid the hazard of high pressure fluid by relieving the
pressure before disconnecting hydraulic lines.
• Check the hydraulic lines and cylinder for leaks before
starting operation each day.
• When machine is not used for some time, exposed
portions of the cylinder rod should be cleaned and
covered with a thick coat of grease. This will prevent
corrosion, which will damage seals.
Do not lubricate machine while machine is in
motion. If any guards are removed for lubricating,
they must be replaced before operating.
Escaping fluid under pressure can be nearly
invisible and have enough force to penetrate the
skin causing serious injury. Use a piece of
cardboard, rather than your hands, to search for
suspected leaks. Wear protective gloves & safety
glasses or goggles when working with hydraulic
systems.