Landoll FPSBT-6 Food Plot Seeder - Manual (Page 18)

2-8 2P102
OPERATION
Figure 2-17: Seed Rate Adjustment (2 of 2)
Seed Rate Adjustment - Rear Agitator
Box
Adjusting the Box Slide: When properly adjusted the
holes in the slide should line up with the holes in the box,
with the control handle set at “6”. To make an adjustment
or loosen the control handle on the box, move the slide
until the holes line up. When the handle in moved to “0”
the holes in the box should be completely covered. If the
holes are not covered, loosen the three bolts holding the
seedmeter casting and shift it slightly so that the “0” mark
is farther from the control handle. Re-tighten the bolts.
Move control handle to “0”. Holes in the box should then
completely covered. See Figures 2-18, 2-19 and 2-20.
Inner Adjusting
Nut
Decrease
Shaft Moves This Direction
Increase
Shaft Moves This Direction
Bearing
End Plate
Outer
Adjusting
Nut
Adjust seed rate by turning
the nuts on the inside and outside
of the bearing with the wrenches
provided.