Landoll 164703 PT PULVERIZER WARNING LIGHT - Manual (Page 4)

1-2
PT PULVERIZER WARNING LIGHT INSTALLATION INSTRUCTION BOOKLET
PT 10 INSTALLATION
!
WARNING
Install light brackets:
1. Position the inner light brackets for red lamps to be
within 48" of the center of the machine. Secure with
the U-Bolt and locknut. See Figure 1-1.
2. Secure outer light brackets with outer bearing hanger
U-Bolts.
Install warning lamps:
1. Install the outer warning lamps (amber) and lamp
shield to outer brackets with ¼-20 x 1-1/2 hex head
cap screws and ¼-20 flanged lock nuts.
2. Install the inner warning lamps (red) to inner brackets
with ¼-20 x 1-1/4 hex head cap screws and ¼-20
flanged lock nuts. Make sure the red lens is rear
facing.
Install electrical wiring and module:
1. Lay out the wishbone harness, making sure the sides
marked left or right are correct.
2. Starting at the center of the machine, thread the
harness ends through openings in the center frame
lift weldment and light brackets, ending at the outer
light bracket.
3. Install the enhanced lighting module by fastening it
with #8 screws, flat washers, lock washers and nuts
(2 each) to the inside of the center frame lift
weldment plate.
4. Lay out the tractor harness on the drawbar, making
connection at the lighting module.
5. Secure the tractor harness to the hydraulic hose with
cable ties, making sure to leave enough slack at the
lift weldment to allow the machine to raise and lower.
6. Connect the wishbone harness to module, bundle
any excess wire and secure with cable ties.
NOTE
Be sure inner light brackets do not interfere with the
frame braces as the machine cycles.
7. Raise the machine if not done previously.
8. Adjust the lamp angles so lamps are vertical with the
drawbar height adjusted to the transport height.
Adjustment is provided to compensate for high
drawbar heights if used as a companion tool or lower
heights if towed directly behind a tractor.
9. Tighten all hardware.
Install reflectors:
1. Install the (4) reflector brackets to center frame end
plates using ½-13 x 1-1/2 hex head cap screws, flat
washers, and lock nuts (8 each).
2. Adjust the bracket angles to be as vertical as
possible with machine raised and the drawbar height
at transport height.
3. Tighten hardware.
4. Apply the reflector decals to brackets. The amber
reflectors should be on the front brackets; the red
and orange fluorescent reflectors should be rear
facing.
5. Apply the remaining 2 amber reflectors to the outside
of each wheel arm. See Figure 1-1.
6. Install SMV emblem to the bracket by fastening it with
2 - 5/16”-18 x 1” screws, flat washers and NY-LOK
nuts.
7. Attach the bracket to the left side of the center
bearing hanger.
NOTE
Final assembly should have red lamps within 48" of the
center of the machine and amber lamps within 16" of
machine extremity.
Lower machine to ground before removing any
hardware