Labnet Z233M-2 High Capacity MicroCentrifuge User Manual
Page 6

6
1.6
Accessories supplied with each centrifuge unit
2 Fine-wire fuses 6.3 AT, 1 Instruction manual, 1 Tool for removing the rotor
1.7
Warranty
This centrifuge has been subjected to thorough testing and quality control during the
production process.
In the unlikely event of any manufacturing faults occuring, the centrifuge and rotors
are covered by warranty for a period of one year from date of delivery.
This warranty becomes invalid in case of improper operation, use of non-
appropriate spare parts or accessories and non-authorized modification of rotor or
centrifuge.
The manufacturer reserves the right to make technical modifications to the
The manufacturer reserves the right to make technical modifications to the
The manufacturer reserves the right to make technical modifications to the
The manufacturer reserves the right to make technical modifications to the
The manufacturer reserves the right to make technical modifications to the
product for the purpose of technical improvement.
product for the purpose of technical improvement.
product for the purpose of technical improvement.
product for the purpose of technical improvement.
product for the purpose of technical improvement.
2.
2.
2.
2.
2.
Installation
Installation
Installation
Installation
Installation
2.1
Unpacking the centrifuge
The Z 233 M-2 is supplied in a carton with corrugated cardboard inserts.
Open the carton and remove the corrugated cardboard inserts, then gently remove
centrifuge from carton. The instruction manual and the accessories mentioned
under 1.6 should be kept with the centrifuge. Please keep all packaging in safe
Please keep all packaging in safe
Please keep all packaging in safe
Please keep all packaging in safe
Please keep all packaging in safe
storage for at least 1 year for warranty purposes.
storage for at least 1 year for warranty purposes.
storage for at least 1 year for warranty purposes.
storage for at least 1 year for warranty purposes.
storage for at least 1 year for warranty purposes.
2.2
Required space
The centrifuge should be installed on a rigid, even surface. The centrifuge should
only be operated on a stable laboratory table/cabinet etc. Balance the centrifuge
with a spirit level. To guarantee the necessary heat dissipation, the unit must be
situated so that there is a space of at least 15 cm on each side of the unit.
Never place the centrifuge in an area subject to excessive heat, e.g., strong
sunlight, as the performance of the unit is based upon an ambient temperature
of +23°C.
Attention:
Attention:
Attention:
Attention:
Attention:
New safety standards require a safety margin space of 30 cm around the
New safety standards require a safety margin space of 30 cm around the
New safety standards require a safety margin space of 30 cm around the
New safety standards require a safety margin space of 30 cm around the
New safety standards require a safety margin space of 30 cm around the
centrifuge. Mark this area to indicate that personnel and dangerous material
centrifuge. Mark this area to indicate that personnel and dangerous material
centrifuge. Mark this area to indicate that personnel and dangerous material
centrifuge. Mark this area to indicate that personnel and dangerous material
centrifuge. Mark this area to indicate that personnel and dangerous material
(e.g. flammable or infectious liquids) should be kept outside this area during
(e.g. flammable or infectious liquids) should be kept outside this area during
(e.g. flammable or infectious liquids) should be kept outside this area during
(e.g. flammable or infectious liquids) should be kept outside this area during
(e.g. flammable or infectious liquids) should be kept outside this area during
operation.
operation.
operation.
operation.
operation.