Labnet Z233M-2 High Capacity MicroCentrifuge - Manual (Page 11)

11
4.4 Preselection of speed / RCF
When the centrifuge lid is open, you can preset the required speed or rcf with the
speed knob (1).
With the "speed/rcf" key (2) you can change the display from speed to g-value.
The green control lamps (3) show which mode is activated. If the centrifuge lid is
closed and during the run, the speed can be changed as follows:
Press the "preset" key (4), hold it and at the same time change speed or g-value
with the speed knob. The max. speed for all rotors is 14 000 rpm.
4 1 2 3
Figure 6
Z233M-2