Brother HL 4040CN - Manual (Page 87)

Wireless configuration for Macintosh ® using the Brother automatic installer application
80
5
q
If your network is configured for Authentication and Encryption, the following screen will appear. When
configuring your Brother wireless printer, you must ensure that it is configured to match the
Authentication and Encryption settings of your existing wireless network. Choose the
Authentication Method and Encryption Mode from the pull-downs in each setting box. Then enter the
Network key and click Next.
Note
• If you want to setup more than WEP key1, click Advanced.
• If you do not know the Authentication or Encryption settings for network, contact your network
administrator.
r
Click Next. The settings will be sent to your printer. The settings will remain unchanged if you click
Cancel.
Note
• If you want to manually enter the IP address settings of your printer, click Change IP Address and enter
the necessary IP address settings for your network.
• The control panel settings will be automatically changed to WLAN when the wireless settings are sent to
your printer.