Koolance ERM-3K3UC-R - Manual (Page 11)

14 15 User Manual Installation
Install the Slot Adapter into any available rear
card slot in your computer.
Screw the Slot Adapter in place as you would
a normal hardware card.
From the rear of the case, carefully feed
both ends of the liquid tubing through the
Slot Adapter and into the chassis.
Installing the Slot Adapter
There are 5 main internal connections to the Slot Interface card which will be made.
The cooling system can appear to operate without some of these connections, but
hardware safety features or temperature monitoring on affected channels will be
disabled.
Start by connecting Temperature Sensors #1, #2, and #3. Then connect the ATX
Pass-Through wire.
Power Signal Connection
To enable a computer to turn the cooling system on and off, the internal power plug
from the slot adapter must be connected.
Plug the external power cable from the
cooling unit into the Slot Adapter.
Connect the Slot Adapter’s power plug to a computer power supply 4-pin Molex
plug.
NOTE: If a computer will be used to turn the cooling system on and off, the front
power switch must be left in the “OFF” (raised) position.