KD Scientific 410 - Manual (Page 8)

6
KDS Model 410 Series Syringe Pumps KDS Model 410 Series Syringe Pumps
Features
(continued)
4) MODES OF OPERATION
Infusion
Rate and volume settings: pump infuses to the set volume and stops.
Rate setting only: pump runs until manually stopped or stalls.
Withdrawal
Rate and volume settings similar to above.
Infusion/withdrawal
Infusion automatically followed by withdrawal. Rate and volume settings can be made
independently for infusion and withdrawal, hence the pump can infuse at one rate and
volume and then change to a different withdrawal flowrate and volume setting.
Withdrawal/infusion
Withdrawal immediately followed by infusion. Separate settings for rate and volume
can be made for withdrawal and infusion.
Continuous operation
The pump cycles from infusion to withdrawal continuously. The volume is identical in
infuse and withdrawal directions.
Note: The displayed menu which prompts the operator for Rate and Volume settings
changes with Mode selection. For convenience, only the relevant settings associated
with the selected mode are prompted. For example, in the Withdrawal / Infusion mode
the menu prompts for withdraw and then infuse volumes, followed by withdraw and
infuse rates. In Infusion only mode, the menu prompts only for infusion volume and infu-
sion rate. In the Continuous mode only one volume is prompted for followed by infusion
and withdrawal flow rates.
5) RS232C INTERFACE
Multiple pumps can be controlled in a "daisy chain" by a single PC.
Programming is reduced to a small number of simple commands.
6) TTL
Input and output controls are available, such as, direction change, run indicator,
footswitch or timer control , and valve or relay actuation.