Start - stop, Setting of temperatures – JULABO SL-26 Heating Circulators User Manual
Page 25
HL / SL
25
6.3. Start - Stop
Start:
Press
key.
The actual bath temperature is displayed on the VFD COMFORT-
DISPLAY. The circulating pump starts with a slight delay.
Stop:
Press
key.
or
Keep
key pressed.
The VFD COMFORT-DISPLAY indicates the message "OFF".
7.
Setting of temperatures
Press the
key to call up the menu for temperature selection.
3 different working temperatures can be adjusted. Their values are freely
selectable within the operating temperature range.
The temperatures can be set in start or stop mode.
Setting of working temperature in the
menu
Factory settings:
1. Press the key
. The value flashes
2. Select SETPOINT 1 or 2 or 3 using the key
or
.
3. Confirm by pressing the
key.
The circulator uses the new working temperature value for
temperature control.
Example:
Adjustment/modification of the pre-setting of "SETPOINT 3"
If the active Setpoint is changed, the new value is immediately used
for the control of the working temperature.
The heater control indicator flashes.
Setpoint3:
Change the value from 70.00°C to 80.00°C.
See standard display line 1
Use the numeric keypad to enter
and
.
Then press enter
to store the value.
Notice: Refer to SETPOINT MAX / MIN in chapter „LIMITS“