JULABO CF40 Cryo-Compact Circulators - Manual (Page 23)

Cryo-Compact Circulator
23
6.5. Setting the temperatures

Setting can be carried out in the start/stop condition.
1. Press one of the keys for a short moment.
The setpoint value instead of the actual value is indicated on the
display for about 8 seconds.
The value can now be changed.
2. Change value:
Press
to set a higher value.
Press to set a lower value.
Keep the keys depressed for the value to change fast.
3. Press enter to store the value.
ESC

Press ESC to update the display immediately, or the unit
automatically returns to the effective display after
about 30 seconds .
6.6. AUTOSTART ON / OFF
The Cryo-Compact Circulator has been configured and supplied by
JULABO according to N.A.M.U.R. recommendations. This means for
the start mode, that the unit must enter a safe operating state after a
power failure (non-automatic start mode). This safe operating state is
indicated by „OFF“ on the LED temperature display. A complete
shutdown of the main functional elements such as compressor and
circulating pump is effected simultaneously.
Should such a safety standard not be required, the AUTOSTART
function (automatic start mode) may be activated, thus allowing the
start of the Cryo-compact circulator directly by pressing the mains
power switch or using a timer.
1. Keep depressed enter and
2. turn on the unit with the mains power switch.
For a short while the LED DISPLAY indicates the effective start
mode:

AUTOSTART on.

AUTOSTART off.