Intelix DIGI-P52 - Manual (Page 18)

DIGI-P52 Installation Guide
18
Front Panel and IR Remote Operation
Source Selection
Output Resolution Selection
Auto Selection:
Press and hold the Source/Auto button for 15 seconds to enable
the Auto Switching mode of the DIGI-P52. This function will not
be available if either of the VGA ports are set to an alternate
analog video format.
Manual Selection:
Press the Source/Auto button to select the desired input.
Auto Selection:
Press and hold the Resolution/Auto button for 15 seconds
to enable the DIGI-P52 to scale the output resolution to the
preferred settings of the display.
Manual Selection:
Press the Resolution/Auto button to cycle through the preset
video output resolutions.
Scaler Switcher
INPUT SOURCE
CEC CONTROL
INPUT 1 INPUT 2 INPUT 3
P.M. ZOOM S.M.
MENU EXIT
1080P 720P AUTO
REV FWD
PLAY/
PAUSE
STOP MENU
INPUT 4 INPUT 5 AUTO
MIC MUTE
LINE MUTE
MIC
LINE
OK
Scaler Switcher
INPUT SOURCE
CEC CONTROL
INPUT 1 INPUT 2 INPUT 3
P.M. ZOOM S.M.
MENU EXIT
1080P 720P AUTO
REV FWD
PLAY/
PAUSE
STOP MENU
INPUT 4 INPUT 5 AUTO
MIC MUTE
LINE MUTE
MIC
LINE
OK
The included IR remote features discrete input selection
buttons. The Auto button on the IR remote will cycle between
Auto and Manual operation.
The IR remote features discrete output resolutions for 720p and
1080p. The Auto button on the IR remote will scale the output
resolution to the preferred settings of the display.