Intelix DIGI-P52 - Manual (Page 15)

DIGI-P52 Installation Guide
15
Connect IR Control (Optional)
Source Device and Scaler Control via Remote IR
Attach the plastic end of the DIGIB-EMT to the IR receiver of the
source device. Insert the TS 3.5 mm plug of the DIGIB-EMT to
the IR output port (IR OUT) of the matrix for the source device
to control.
The DIGI-P52 has an advanced bidirectional IR control protocol through the HDBaseT output port, which allows
for the control of the sources, displays, and presentation switcher. Intelix recommends using the DIGI-HD60C-R
for installations which require IR extension.
Only use the included IR components, DIGIB-EMT (IR transmitter) or DIGIB-EYE (IR receiver) with the DIGI-P52.
Third party 12V DC IR components are not compatible with the DIGI-P52.
An IR signal passed from the display location through the HDBaseT connection can provide control of the
source device. The IR signal from the remote display location can also control the switching of the scaler.
Remote Display and Scaler Control via Local IR
Insert the TRS 3.5 mm plug of the DIGIB-EYE to the IR input port
(IR IN) of the scaler.
An IR signal may be passed to a remote display location through the HDBaseT connection. In order to control
the DIGI-P52 via IR or extend an IR signal to a remote display, the included DIGIB-EYE must be connected to the
IR input port (IR IN) of the scaler.