Intelix DIGI-P52 - Manual (Page 13)

DIGI-P52 Installation Guide
13
Connect Displays
HDMI Output
HDBaseT Output
Connect the display devices to HDMI outputs using HDMI
cables that are less than or equal to 5 meters in length. For
display devices that are further away, it is highly recommended
to utilize the HDBaseT output.
For all HDBaseT cabling, the EIA/TIA-568B crimp pattern must
be used on Category 6 or greater cable. In areas with large
amounts of electromagnetic (EM) or radio frequency (RF)
interference, a shielded variety of Category 5e or greater cable
is recommended with shielded connectors on both ends of the
selected cable.
The HDBaseT output provides 15 watts of Power over Ethernet,
which eliminates the need for a power supply with a compatible
HDBaseT receiver. Intelix recommends using the DIGI-HD60C-R
or DIGI-HD60-R for installations which require remote power.
Connect the HDBaseT receiver to the display per the
manufacturer’s instructions. Connect the HDBaseT cable to the
scaler and the HDBaseT receiver.
TIA/EIA-568B
Orange/White
Orange
Green/White
Blue
Blue/White
Green
Brown/White
Brown
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
1 8