INFICON RS-3000 Power Supply Controller - Manual (Page 20)

instruments
Power Supply Controller RS-3000
Table 4-3 Remote Mode
Event From To Description
RMT key O.F.F. mode REMOTE mode Starts Remote mode. RS-3000 needs to be
connected to an STC-2000 or equivalent. The large
display shows current and the small display shows
kilowatts. The RMT indicator is illuminated.
RMT key REMOTE mode MAN mode Toggles Remote mode off and automatically starts
the Manual mode (see Manual mode START)
retaining the last current value held in the Remote
mode. As previously described for the START key
event entering Manual mode, the large display shows
current and the small display alternates between
showing kilowatts and minutes. The RMT indicator is
now off and the MAN indicator is illuminated.
STOP key REMOTE mode O.F.F. mode Ends Remote mode. The pendant STOP key
provides this same function.
Table 4-4 Program Mode
Event From To Description
PRGM key any mode (except
the PRGM mode) PRGM mode Starts Program mode. The PRGM indicator blinks
while in the Program mode. The first in a
sequence of six user programmable parameters is
shown (that of maximum current). The INC/DEC
keys provide the means to make a value change.
PRGM key PRGM mode PRGM mode For the 2 nd press of the PRGM key while in the
Program sequence, Ramp minutes can be altered
by the INC/DEC keys (range is 0-99.9 minutes).
For the 3
rd press of the PRGM key while in the
Program sequence, Ramp current can be altered
by the INC/DEC keys (range is 0-600 Amps). For
the 4
th press of the PRGM key while in the
Program sequence, beeper configuration can be
altered by the INC/DEC keys (select: ON or OFF).
For the 5
th press of the PRGM key while in the
Program sequence, communication speed can be
configured by the INC/DEC keys (9.6, 38.4 or 115
kbaud). For the 6
th press of the PRGM key while in
the Program sequence, address can be
configured by the INC/DEC keys (0-9). The 7
th
press of the PRGM key while in the Program
sequence, terminates the PRGM mode and the
PRGM indicator ceases to blink. Parameters are
saved immediately as they are entered (there is
no quit without saving). If there is a lack of activity
for 30 seconds during the programming sequence,
the programming mode will auto-terminate.
Section 4 Page 4 - 3 Specifics