Hydrolevel 3200-Plus - Manual (Page 4)

4
WIRING
WARNING Electrical shock hazard. To prevent electrical shock, death or equipment damage, disconnect power supply before
installing or servicing this control.
STEP 1
Connect 120 VAC Hot to terminal L1. Connect 120 VAC
Common to terminal L2. Disconnect means and overload
protection as required (provided by others).
STEP 3
Connect the circulator to C1-C2. (C2 is common.)
STEP 2
Connect the burner circuit to B1-B2. (B2 is common.)
STEP 4
Connect the thermostat to T/TV.
STEP 5
If the boiler is equipped with a plug-in style vent damper,
unplug the factory installed jumper from the receptacle on the
circuit board and replace it with the vent damper plug.
HydroStat 3200-Plus Instructions: HydroStat Instructions.8pg 11/14/13 3:34 PM Page 4