Heidolph SilentCrusher S - Manual (Page 36)

36
E
 Attrition (PTFE particles) at bearing
o Tools were operated without or with too little liquid; clean tool, if necessary
exchange bearing. Please note the filling quantities of test tubes (p. 23).
If malfunctioning occurs that cannot be corrected with the above instructions, please
inform your authorized Heidolph Instruments dealer immediately.
TECHNICAL DATA
SilentCrusher S
Characteristics Values
Connection Voltage 100 – 240 V / 47 - 63 Hz
Power Consumption (Rated Output) 24 W
RPMs 15.000 – 75.000 rpm (referred to water)
Operating Mode Short-term operation, 1.5 minutes, automatic
shut-off, red control light indicates shut-off.
Reset by removing dispersing tool.
Drive Protection Overheating protection switches drive unit off
in case of overheating; blinking red control
light indicates this condition. Reset by
removing dispersing tool.
Control Light for “Device On” Control light (green) on power supply
Dimensions (in mm) Drive Unit Width 125; height 197; depth 125
Dimensions (in mm) Power Supply Width 106; height 30; depth 65
Total weight 1.1 kg
Operating Temperature 0
– 40 °C
Storage Temperature - 20 to + 80 °C
Relative Humidity 85 % (without condensation)
Type of Protection according to EN
60529 IP 30
Safety Class according to VDE 0100 I