Heidolph SilentCrusher S - Manual (Page 24)

24
E
Dispersion Tool 5 F including 10 PP
– 5ml test tubes and
2 PTFE bearings and spare part set
596-05010-00
PP
– 5ml Test Tubes, 100 units 596-00005-00
Dispersion Tool 7 F including 10 PP
– 20ml test tubes
and 2 PTFE bearings and spare part set
596-07010-00
PP – 20ml test tubes; 100 units 596-00007-00
GENERAL INFORMATION
Please unpack the device carefully.
Check for any damage and report damage or missing parts to the supplier immediately.
Read the operating instructions thoroughly and attentively and ensure that every
operator of the device has read the operating instructions carefully before start-up.
Please keep the operating instructions in a location accessible to everyone.
The device is equipped with a EUROPEAN plug in accordance with the standards
(DIN 49441 EEC 7/VII 10/ 16 A 250 V).
For North America with a US STANDARD plug (NEMA Pub. No. WDI.1961 ASA C 73.1.
1961 page 8 15A 125V).
If you wish to use the device in a country with a different electrical outlet system, you
must use an adapter or have the plug supplied with the equipment replaced by a
technician with an approved plug suited for this power supply system.
The device is grounded when delivered. If the original plug is changed, you must make
absolutely sure that the protective ground wire is connected to the new plug.
SAFETY INSTRUCTIONS
Please follow all safety and accident prevention provisions in effect in the
laboratory.
Before plugging the device into the power supply circuit, ensure that the mains
voltage matches the data on the rating plate.