Heidolph SilentCrusher S - Manual (Page 35)

35
E
DISASSEMBLY, TRANSPORT AND STORAGE
Disassembly
Remove the mains plug and disconnect the connecting socket from the Power Supply
(unit) to the drive unit.
Remove the dispersing tool from the drive unit.
Transport and Storage
1. The device and its parts should be stored preferably in the original packaging or
in another suitable container, to prevent damage during transport. The best
material to seal the packing is adhesive tape.
2. Keep the device in a dry location.
Warning
Avoid shaking and shocks to the device during transport.
DISPOSAL
Dispose of used or defective devices properly in a collection location.
Separate recyclable material into metal, glass, plastic, etc.
Dispose of the old packing material in an environmentally friendly manner (material
separation).
TROUBLESHOOTING
 The device does not disperse
o Check electrical connections (power supply system und power supply (unit))
o Dispersing tool not inserted into drive unit up to stop
o Maximum dispersion time reached, red control light goes on (see Service
and Operation)
o Permissible temperature exceeded for drive unit, red control light blinking
(see Service and Operation)
 Rotor not mounted in tool
o Rotor sluggish (check PTFE bearing, see Cleaning and Maintenance)
 Loud noise when dispersing
o PTFE bearing worn, must be replaced (see Cleaning and Maintenance)