Heidolph MR Hei-End - Manual (Page 43)

41
E
13 Error messages
Note
If an error message appears, start by resetting the instrument: switch it
off and unplug it from its AC power outlet. After a few seconds, plug the
instrument back in and switch it on.
Error message Description Remedy
hot plate sensor break Defective hotplate sensor Service required, please
contact your laboratory
equipment dealer
hot plate sensor shorted Short circuit in hotplate
sensor Service required, please
contact your laboratory
equipment dealer
safety sensor break Defective hotplate safety
sensor Service required, please
contact your laboratory
equipment dealer
hot plate safety sensor
shorted Short circuit in hotplate
safety sensor Service required, please
contact your laboratory
equipment dealer
hot plate sensor difference
>15°C Excessive temperature
difference, hotplate sensor Service required, please
contact your laboratory
equipment dealer
external sensor break Defective external sensor Replace external sensor
external sensor shorted Short circuit in external
sensor Replace external sensor
external safety sensor break Defective external safety
sensor Replace external sensor
external safety sensor
shorted Short circuit in external
safety sensor Replace external sensor
external
sensor difference >15°C
Excessive temperature
difference, external sensor Replace external sensor
set safety

T safety temperature
exceeded Measurement within
reaction: indication of
exothermal reaction.
Controlled system too slow:
Increase safety
temperature
triac IDxx Triac error Service required, please
contact your laboratory
equipment dealer