GeoDesy GD-P1000E1000 - Manual (Page 22)

22
GeoDesy Kft. Telefon: 06-1-481-2050
H-1116 Budapest, Kondorfa str. 6-8. Fax.: 06-1-481-2049
E-mail: [email protected]
http://www.geodesy.hu
On the LCD screen you can see the remote level of the other Laser Head!
Because of the weight of the heads for the
vertical moving you can use the spacers as it is
shown on the figure. For this moving you need
two wrencches. With one of them you have to
hold the head of the bolt, and with the other you
can turn the thick nuts to lift or loose the plate of
the ABU!
To not enable any movement after the receiver
alignment on the vertical angle of the head and
due to the heat expansion please close the
locking nut under the thick nut, as it shown on the
figure, on both sides.
Please not before the vertical reciver alignment we strongly suggest doing the
horizontal the same way as it is written above.
9.2 Beam Alignment

Swich off all of the transmitters on both sides.

Switch on one of your transmitters on one side.

Move the beam the middle of the remote head.
You can move the beam with the screws on the back of the transmitters. The
directions of beam moving in the functionof the turning direction of the screws can be
seen on the figure.