General Machine Products 71500 Sierra Cable Lasher - Manual (Page 12)

Page 12 of 16 General Machine Products Co., Inc.
The lashing wire won’t pay out: This indicates the wire isn’t threaded
properly. Refer to “Loading Wire Spools On the Lasher” in section 6.0.
Note: if you are unable to achieve positive drive, the lashing wire may
need to be threaded twice around the friction wheel.
The wire jumps off of the wire guide tension roller: This indicates the
lashing wire is improperly threaded. Refer to “Loading Wire Spools On
the Lasher” in section 6.0.
The lasher draws back and loosens lashing wire: just pull lasher forward
so the wire will tighten.
If you need any parts or repairs: contact
General Machine Products Co., Inc.
3111 Old Lincoln Hwy
Trevose, PA 19053 • USA
TEL: +1-215-357-5500 • FAX: +1-215-357-6216
WEB: http://www.gmptools.com
EMAIL: [email protected]
8.0 TROUBLE SHOOTING