General Machine Products 15326 B Ladder Platform - Manual

Ladder Platform
About your Ladder Platform
The Ladder Platform PIN 15326 is a convenient tool
to facilitate work being performed from a ladder. Craft
people have found that it reduces fatigue while working
aloft by affording a sturdy perch upon which the worker
may sit or stand. It consists of a welded, hinged pipe frame
assembly equipped with spring-actuated latches to secure
the platform onto the rungs of the ladder. The wooden seat
is bolted to the upper frame and finished with a skid-
resistant surface to protect against slipping.
IMPORTANT:
The Ladder Platform is suitable for use only on all alumi-
num or fiberglass rail/aluminum rung ladders with
rung diameters from 1 1/4 in. to 13/8 in. (32 to 41 mm)
inclusive; on either round or “D" cross-section rungs.
CAUTION!
NEVER use the Ladder Platform on any ladder other
than those described above. The Ladder Platform may
not latch properly, resulting in an increased risk of a fall.
For the same reason, you should NEVER attempt to
modify the Ladder Platform to fit any ladder other than
those described above.
IMPORTANT:
The Ladder Platform is rated for a maximum load of
375 lbs. (170 kgs).
CAUTION!
It is unsafe to exceed the maximum working load of the
Ladder Platform.
PRECAUTIONS:
In addition to the precautions contained in your employer's
work practices, the following additional precautions
should be observed:
Always inspect the platform carefully before each use to
determine that it is in satisfactory condition.
Unsatisfactory conditions to look for are:
Breaks or cracks in the wooden seat
Loose or missing bolts or nuts
Defective hardware such as spring latches that do not
operate properly
Excessive wear such as a damaged or broken weld or
bent pipe
Need for refinishing of the skid-resistant top surface
If inspection reveals any unsatisfactory condition, tag
the unit as "Defective - Do Not Use" and exchange the
unit in accordance with your employer's procedures or
return it directly to GMP for repair or replacement.
Only one person should be on the ladder or the ladder
platform at any time.
Before climbing on any ladder, be sure that it is completely
stable and positioned well away from all electrical
hazards in your workspace.
When working from the platform, a lineman's body belt
must be worn and the safety strap shall pass through
both "D" rings of the body belt and be snapped to the
strand on each side of the craft person.
Installation
The standard work procedure calls for the E Ladder
Support P/N 86350 or 86351 to be used for supporting
the upper end of an extension ladder away from the
cable and strand. After the ladder support has been fas-
tened to the strand and the ladder placed in position in
accordance with the instructions for the ladder support,
you should determine the desired working position. For
a seated position, the platform will usually be placed
with the lower hooks on the fourth rung from the top of
the ladder affording a seating position on the third rung
from the top. For a standing position, the platform will
usually be placed with the lower hooks on the seventh
rung from the top affording a standing position on the
sixth rung from the top.
Raise the ladder platform in the collapsed position to the
desired working position and rest the lower hook frame
on top of the ladder rung so that the lower tab of the
latch rests against the back of the rung. As you draw
the lower hook frame towards you, the tab opens the
bottom latch, allowing the hooks to drop down over the
rung and the latch automatically springs closed once the
hooks are fully seated over the bottom rung. As the top
hooks are placed over the next higher rung, the springactu-
ated latch on the bottom of the seat automatically
encloses that rung and secures the platform on the ladder.
To remove the platform, release the top spring-actuated
How to Use Your New...
The top surface of the platform is coated with a non-skid finish.
!
!
!
!
!