General Machine Products 84850 C Pull Finder with Case - Manual

Underside view of guy
rod and strand gauge
Back
Sight
Front
Sight
Front
Sight
Index
Mark
Screw
Thread
A
C
B
To Measure Pull
To determine the pull at a
corner pole by use of the C
Pull Finder, screw the short
arm A into the corner pole,
as illustrated in figure 2.
Adjust arm C so that the line
of sight, when sighting over
the back sight and the front
sight on arm C, is tangent to
the surface of the pole adja-
cent to the corner. In a simi-
lar manner, line up arm B,
sighting on the other pole
adjacent to the corner.
Check arm C to make cer-
tain it has not moved. The
pointer on arm B now indi-
cates, on the scale on arm
C, the pull in feet at the
corner.
A
B C
Figure 2
Figure 1
General Machine Products, Co., Inc.
3111 Old Lincoln Hwy, Trevose, PA 19053
tel: 215-357-5500 www.gmptools.com
Over for Bisecting Angle instructions
C Pull Finder P/N 84850
p/n 27936 ver 1 AK