Gamber-Johnson 7160-0380 - Manual (Page 2)

FIG. 1 - Replace Child Seat Anchors FIG. 2 - Top Cross Bar Installation
Shelf Installation:
1. Using the supplied 1/4"-20 x.75" bolts, 1/4" lock washers and 1/4" flat washers, loosly assemble
the Side Brackets to the Shelf Assembly (Fig 5).
2. From inside the trunk, install the Top Cross Bar using the supplied 5/16" washers and nylock
nuts. Note: The Top Cross Bar has a traingular cutout that should point to the front of the car.
Caution: Do not over tighten nuts as doing so may deform the Top Cross Bar.
3. Place shelf assembly in truck and hang on 1/4"-20 studs on ends of the Top Cross Bar (Fig. 2).
4. From inside cabin, place Backer Plate into outer most obround depression and use as a template
to mark and drill two (2) 5/16" diameter holes per side (Fig 3). Caution: Check for cables, wire
harness or other equipment before drilling into the vehicle
5. Using supplied 1/4"-20 x .75" bolts, 1/4" lock washers and 1/4" washers, bolt through Backer
Plate, rear seat wall and into threaded inserts on back of Shelf Assembly rails (Fig 4).
6. Tighten Side Bracket hardware (3 per side).
7. Reinstall rear seat.
FIG. 3 - Drill Backer Plate Mounting Holes
Driver Side Shown
FIG. 4 - Backer Plate Hardware
Inside Cab
Inside Trunk
Factory Bolt
Not Used
Provided Bolt
with Factory Hardware