Gamber-Johnson 7160-0446 - Manual (Page 2)

Fig 5 - Front Sub Structure Screws
Fig 4 - Side Trim Pieces Fig 3 - Pry Up Console Top
6. Gently pull up at storage bin/low range switch (behind shifter) to remove
console top (Fig 3).
7. Disconnect all harness for the console top.
8. Pop the storage bin or low range switch out of console top.
9. Pull to remove side trim pieces from console (Fig 4).
10. Remove two bolts at the front of the console (Socket M10)
11. Remove three bolts retaining the shifter assembly (Socket M10).
12. Unplug the interlock harness on the back of the shifter assembly.
13. Remove shifter assembly from console and set on driver side foot well being
careful not to damage shifter linkage cable.
14. Unplug the main harness from the 12v accessory jacks. Pull out Christmas tree
fasteners so harness can be laid in passenger foot well (Fig 7).
15. Remove two screws at the front of the console sub structure (Fig 5).
16. Slide seats all the way forward. From the back seats, pop out rear bolt covers
on the side of the console and remove bolts (Socket M10) (Fig 6).
17. Remove console sub structure from vehicle.
18. Recommended: Stuff something (clean rag) into the HVAC tube under the
front of the dash to protect the electronics from excess heat in cold weather.
Fig 6 - Rear Mounting Bolts