Gamber-Johnson 7160-0446 - Manual

Rev.A
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
7160-0445, 7160-0446
DODGE DURANGO CONSOLE Description
INSTALLATION INSTRUCTIONS
INST-581
Fig 1 - Shifter Removal
Product Revision
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Printing Spec: PS-001
Form
Fig 2 - Retaining Clip
Vehicle Disassembly
1. Begin by disassembling vehicle OEM console.
2. Set vehicle parking brake and place shifter into neutral position. Disconnect
vehicle battery.
3. Using a small flat head screwdriver, pry down on chrome ring around shifter
knob (Fig 1).
4. Pull out the shifter retaining clip on passenger side of shifter knob (Fig 2).
5. Pull up to remove shifter knob and chrome ring.
EXTENSION
DASH FILL
AND ANGLE ADJ.
ARMREST HEIGHT
TOP PLATE
PLATE
SHIFTER GATE
SPREADER PLATE
© copyright 2011 Gamber-Johnson, LLC