Gamber-Johnson 7160-0028 - Manual

INSTALLATION INSTRUCTIONS
Product Revision Form #
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
MCS EXTENSION BOX
7160-0028 Rev B INST-329
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
The purpose of this instruction sheet is to illustrate the manufacturer's recommended
method of installation of the EXTENSION BOX. This console box can be used as an
addition to either the MCS-ERGOBOX, or the MCS-LOWBOX, or as a stand alone
product mounted directly to a Gamber Johson Top Plate (p/n 7160-0085 or 7160-0086).
The EXTENSION BOX is intended to mount one two remote head radios.
1. If attaching the Extension Box to the MCS-ERGOBOX or the MCS-LOWBOX,
there are two slots available on the backside of the Extension Box for fasteners to pass
through into either of the mentioned concole boxes (see FIG. 1).
FIG. 1
Extension Box attached to
MCs-ERGOBOX
Mounting
Slot
Extension
Box
MCS-ERGOBOX
2. If attaching to another console box, it is
recommended, in addition to Step 1, to attach the box
to the top plate (p/n 7160-0085 or 7160-0086) using
the mounting slots on the bottom of the box and the
included fasteners in hardware bag 7120-0111.
Extension
Box
Top Plate
FIG. 2
Extension Box attached to
a Gamber Johnson Top
Plate.
3. For a discreet, low profile solution, the Extension
Box can be used as a stand alone product mounted
directly to a Gamber Johnson Top Plate using the
included fasteners in hardware bag 7120-0111 (see
FIG. 2).
SHT 1 OF 3