Gamber-Johnson 7160-0053 - Manual

INSTALLATION INSTRUCTIONS
Product Date Form #
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
12" LOCKING SLIDE ARM
7160-0053
7-12-07 INST-337
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
1/3
WARNING
•You must read and follow all of these installation instructions. Failure to follow all of
these installation instructions may result in serious bodily injury or death.
•Do not install or use the 12" Locking Slide Arm in the area in which the airbag on the
vehicle will be deployed if it is activated. The installer and user of the 12" Locking Slide
Arm are responsible for installing and using the 12" Locking Slide Arm outside the area in
which an airbag will be deployed if activated. (See Product Mounting Disclaimer Below)
•Keep these installation instructions with the product and readily available in the vehicle
for future reference of other users of the product.
•Additional copies of the installation instructions can be obtained from Gamber-Johnson.
If you need assistance or have any questions, call Gamber-Johnson at 1-800-456-6868.
•Do not remove warning label from product under any circumstances.
Installation:
The 12" Locking Slide Arm can be mounted directly to a flat base or on top of a DS-56
or other type of mounting equipment that contains a Gamber-Johnson swivel pattern
cutout.
1. To mount on a flat base, drill three 9/32" holes in the base that will allow the
1/4-20unc studs that protrude down from the base to pass through. You can use the
round backup plate (found in the hardware bag) as a pattern for drilling the holes.
Attach the 12" Locking Slide Arm to the flat base by inserting the studs through the
holes. Attach the backup plate to the bottom side of the flat base with the flat washers
and lock nuts provided in the hardware bag. (See Figure 1.)
2. To mount on a DS-56 or other type of mounting equipment that contains a
Gamber-Johnson swivel pattern cuttout, set the base on the mount so the 1/4-20unc
studs protruding through the cutouts. Two studs should protrude through one of the
cutouts and one stud should protrude through the opposite cutout. Attach with the flat
washers and lock nuts that are provided in the hardware bag. (See Figure 2.)