Gamber-Johnson 7160-0381 - Manual (Page 3)

WARNING
•This assembly should not be positioned in the area where the airbag may be deployed.
•DO NOT position the equipment in front of an airbag. Equipment positioned in front of an
airbag may cause serious injury or death if an airbag is activated.
•
If installation of the equipment requires that the equipment be placed in front of an airbag,
the airbag should be deactivated. In order to secure permission for deactivating the airbag
you must contact the National Highway Traffic Safety Administration at 1-800-424-9393 to
gain permission to do so. If you have any questions or need assistance, call
Gamber-Johnson at 1-800-456-6868.
•
High speed vehicle turns may cause parts of the assembly to swivel, interfering with the
driver or other equipment.
Impoving Stability:
Gamber-Johnson recommends the use of a Support Brace with this product. Once a
lower pole is installed (not included), install a Support Brace (7160-0230, not included).
The Support Brace should be installed from the highest position on the lower pole and
can be secured to a bolt behind the dash trim panel (Fig. 3) or any other secure point.
Install the Support Brace per its included installation instructions.
Further stability can be attained by bolting the vehicle base, though the provided hole, to
the floor of the car. Caution: Check for wire harness, fuel lines or other vehicle systems
before drilling through the floor.
FIG. 3 - Recommended Support Brace Anchor