Flint & Walling CCF Series Air Induction Water Treatment Systems - Manual (Page 5)

5
remier remier
roducts roducts
P P
P P
WATER TREATMENT
®
Automatic Water Filters
3. Locate in correct relationship to other water
treatment equipment (See Figure 1).
4. Allow sufficient area around the equipment for
service.
FACTS TO REMEMBER WHILE PLANNINg
yOUR INSTALLATION
1. All installation procedures MUST conform to local and
state plumbing codes.
2. If lawn sprinkling, a swimming pool or geothermal
heating/cooling are to be treated by the Chemical
Free filter, a larger model filter MUST be selected to
accommodate the higher flow rate demands.
3. IMPORTANT: Always use Teflon tape on threaded
plastic fittings. NEVER use pipe dope, as it will
deteriorate the plastic fittings.
CHECK WATER PRESSURE
Minimum water pressure required at the inlet of the
filter is 20 psi. IF PRESSURE IS OVER 100 PSI, A PRESSURE
REGULATING VALVE MUST BE INSTALLED TO REDUCE
WATER PRESSURE.
NOTE: Pressure regulating valve must be installed in
water line ahead of the air induction assembly.
CHECK PUMPINg RATE OF WELL PUMP
The pumping rate of your well pump must be sufficient
to properly backwash the filter. Check backwash flow rate
required for specific filter model.
Water Pressure Low _____ psi
High _____ psi
Pumping Rate _________ GPM
Figure 1 - Standard Installation
FILTERED WATER
FILTERED
SOFT WATER
WATER
SOFTENER
WATER
FILTER
PRESSURE
TANK
PRESSURE
SWITCH
WELL WATER
FROM PUMP
IL1039