Installing the station into the backbox, Unison heritage series – ETC Unison Heritage Button Station User Manual
Page 3

E T C I n s t a l l a t i o n G u i d e
Unison Heritage Series
Unison Heritage Button Station
Page 3 of 4
Electronic Theatre Controls, Inc.
c:
Use the WAGO CAGE CLAMP connector to connect the
installed ground wire to the pigtail wire provided. Open the
terminal levers on the WAGO connector and insert the
installed (typically green/yellow) ESD drain (ground) wire and
the green/yellow lead from the pigtail into the terminals.
d:
Close the levers onto the wires.
e:
Install the ground spade onto the receptacle on the Heritage
Button Station control board.
Installing the Station into the Backbox
Spacers are provided to help align the station and cover flush against the wall
in flush mount applications. The spacers are not needed on surface mount
backboxes.
Step 2:
If needed, fold the receptacle spacer in a zig-zag fashion and press
together to achieve the required thickness to fill the gap between the
station and backbox. Cut off the excess and place between the
station and flush backbox.
Step 3:
Secure the station with two screws. If using spacers, insert the
screws through them.
N o t e :
A ground connection is required for all Heritage Button Station
assemblies if not installed in a grounded metal backbox.
N o t e :
For some flush mount applications with certain trim rings it may
be necessary to remove the station’s back cover for installation
into the backbox.
1
3
2
4
Step 1:
Insert the station
electronics and
wiring into the
backbox. The
arrow on the
mounting plate
must point up.