Change out the af cards (if present), N o t e – ETC Sensor+ CE Rack (ESR+) CEM+ to CEM3 Retrofit User Manual

Page 13

The Retrofit

Step 6:

Insert the backplane tabs in the

sides of the rack.

Step 7:

With the tabs fully inserted in the

sides of the rack, pull the

backplane towards the front of

the rack to line up the screw

holes in the upper side corners

to line up.

Step 8:

Install one screw with a sleeve in the upper-corner of each side of the backplane.

Change out the AF Cards (if present)

If your rack supports Advanced Features (AF) you will need to replace the AF cards as well.

AF cards are located on the right side of the dimmer module slot between the copper

neutral busses and the dimming circuitry cards.

To replace the AF cards:

Step 1:

Remove the old AF cards by flipping the white

retainer tab on the cards into the down

position.

Step 2:

Pull the old cards out of the slots.

Step 3:

Set the DIP switches on the new cards

according to the chart below. Only the first two

DIP switches are used.

Step 4:

Slide the new AF cards completely into the

vacant slots starting with card #1 in the top.

The number of cards depends on rack size.

Step 5:

Flip the white tab up to lock the new card in

place.

N o t e :

You cannot use the old screws without the additional shoulder-sleeve as they will

block the CEM3 from being fully inserted.

Screw with

sleeve

Flip tab down, pull card out

AF Card Addressing

Card 1
Card 2
Card 3
Card 4

1 SR3-6

SR3-12

SR3-24

SR3-48

Sensor+