ETC Source Four CE MultiPAR - Manual (Page 6)

English
6 Source Four MultiPAR CE
Lens identification
Lenses for the Source Four MultiPAR CE come in four versions. The type or beam spread can be identified by the
lens texture.
Accessories
Changing Source Four MultiPAR CE lenses
Removing a lens
1.
Disconnect power from the fixture before attempting to remove or install a lens.
2.
Source Four MultiPAR CE lenses become hot while in operation. Let the fixture cool before handling the lens.
3.
Place the fixture on a flat, stable work surface.
4.
Tilt the front of the fixture down at least 45 degrees.
5.
Press one (or both) of the spring clips with your finger(s) to release the lens. (
Figure 2
).
6.
Allow the lens to drop forward from under the clip.
7. When the lens drops, remove your finger, maintain pressure on the clip while sliding your finger(s) off the clip.
Allow the lens to slide forward until you can grip it securely.
8.
Carefully remove the lens from the fixture.
ETC Part #
Colour frame 19 cm
sq./17cm inside diameter)
7061A3047
Safety cable (79 cm) 7060A1022
Very Narrow Spot lens 7061A4002
Narrow Spot lens 7061A4003
Medium Flood lens 7061A4005
Wide Flood lens 7061A4006
Set of four Source Four PAR lenses
(VNSP, NSP, MFL, WFL)
7061A1013
WFL
VNSP
MFL
NSP
Very narrow spot
Clear glass
15° Round beam shape
Narrow spot
Stipple glass (slight diffuse texture)
19° Round beam shape
Medium flood
Fewer facets, sized 6 x 22mm
21° x 34° Oblong beam shape Wide flood
Many facets, sized 6 x 12mm
30° x 51° Oblong beam shape
Figure 2