ETC Source Four CE MultiPAR - Manual (Page 5)

English
Source Four MultiPAR CE 5
Installing the HPL lamp
Always replace the lamp if it becomes damaged or deformed. Use care installing the lamp. Improperly installed
lamps will cause premature lamp and socket failures.
1.
Disconnect power before installing the lamp.
2.
Let the lamp cool before replacing.
3.
Loosen the captured screw on the back of the raceway and open the raceway lid.
4.
The raceway lid is designed to remain open using gravity. If lid swings shut, reposition the MultiPAR unit using
the hanging irons or trunnions to lock the unit in position.
5.
Remove lamp socket by loosening the gnurled knob and removing the socket assembly. Remove the HPL
lamp from its box, holding it by the base.
6.
Insert lamp base into pin holes in socket assembly.
7.
Push down on the lamp base until the lamp is firmly inserted. Make sure that the lamp is fully seated, with the
bottom of the lamp heat sink flush to the socket assembly surface.
8.
To reinstall the socket assembly, insert until the heat sink base rests flush against the reflector, then tighten the
knurled bolt to secure the socket assembly in place. See (
Figure 1 )
N o t e : To avoid premature lamp failure, do not touch the lamp glass with your fingers. If you touch the
lamp during installation, clean it carefully with rubbing alcohol and a clean, lint-free cloth before
operation.
HPL lamps
WARNING: Use of other lamps may pose a safety risk, damage the fixture, and will void your warranty.
Lamp code Watts Volts Color temp Ave rated life
HPL 375/230X 375 230 3,000ºK 1,000 hours
HPL 375/240X 375 240 3,000ºK 1,000 hours
HPL 575/230 575 230 3,200ºK 400 hour
HPL 575/230X 575 230 3,050ºK 1500 hours
HPL 575/240 575 240 3,200ºK 400 hour
HPL 575/240X 575 240 3,050ºK 1500 hours
HPL 750/230 750 230 3,200ºK 300 hours
HPL 750/230X 750 230 3,050ºK 1500 hours
HPL 750/240 750 240 3,200ºK 300 hours
HPL 750/240X 750 240 3,050ºK 1500 hours
Lamp Base
Raceway Interior
Figure 1
Reflector Socket Assembly