ETC Source Four CE MultiPAR - Manual (Page 4)

English
4 Source Four MultiPAR CE
Source Four MultiPAR CE guidelines
The Source Four MultiPAR CE is intended for professional use only. Read the entire User Guide before using
equipment.
Please note the following safety precautions:
• Do not mount the Source Four MultiPAR CE on or near a flammable surface.
• Use the Source Four MultiPAR CE in dry locations only, where humidity does not exceed 90 percent.
• The fixture is for indoor use only and is not intended for outdoor use.
• For temporary installations, mount and support the Source Four MultiPAR CE only by the primary suspension
yoke holes. Suspend the fixture from a hook clamp or a stand mount, using a securely tightened steel bolt (up to Ø
12 mm), flat washer and locking washer.
• In addition to primary suspension, attach a safety cable (Model 400SC) or chain to the secondary suspension
point on the Source Four MultiPAR CE.
• If the external cable is damaged, it shall be replaced by ETC or our service agents.
• Always hang the Source Four MultiPAR CE with the colour frame held securely behind the MultiPAR retaining
channel.
• Always replace the lamp if it becomes damaged or thermally deformed.
• Lighted objects at this distance or greater will not exceed 90ºC temperature from projected light.
• Disconnect the unit from power before all cleaning and maintenance.
• The Source Four MultiPAR CE is suitable for indoor use with a maximum ambient temperature: T
a
=45°C
• Maximum exterior surface temperature: T
max
=200ºC
• A multilingual label sheet is included with this manual. Affix the label of the appropriate language over the existing
warning label on the extension yoke. Do not cover ETC trademark or CE mark.
• The Source Four MultiPAR CE contains a CE safety screen that covers the lens in the event of accidental dis-
charge. Do not remove the safety screen.
• Keep the luminaire at least 0.7 meters away from anything it is shining on.
Wiring and power information
A plug of at least 2.5 amp (220/240V) rating should be attached to the fixture’s mains lead. The wires in the mains
lead are 1.5mm
2 each and coloured in accordance with the following code:
WARNING: The CE Source Four MultiPAR must be earthed.
Power requirements
The Source 4 MultiPAR CE has several different standard, as well as custom configurations of electrical circuitry.
Make certain you are familiar with the wiring of the MultiPAR and that you have sufficient power (dimmer capacity)
to operate the fixture. Make sure that the total wattage used by your MultiPAR does not exceed the power avail-
able by dimmer.
Green and Yellow: Earth
Blue: Neutral
Brown: Live
Current rating: 240V/2.5 amp maximum
Operating fre-
quency:
50/60Hz
0.7m
t 180 ° c