ElmoMC Multi-Axis Motion Controller-Maestro Installation Guide - Manual (Page 31)

Maestro Installation Guide Maestro Software Setup
MAN-MASIG (Ver 1.33)
4.4.1 Peer-to-Peer Connection
When connecting a Maestro directly to a PC, select Start/Settings/Control Panel to open the
Control Panel and then select Network and Dial-up Connections/Local Area
Connection/Properties to set the IP address of the Maestro manually.
In the Internet Protocol Properties menu select the Use the following IP address option and
enter 10.0.0.2 for the IP address and 255.0.0.0 for the Subnet mask.
Select OK in the Internet Protocol Properties dialog, and OK in the Local Area Connection
Properties box.
Maestro's delivered from the factory have an IP Address of 10.0.0.56 and Subnet Mask of
255.0.0.0. After communications have been established, the IP address can be changed
with the help of the command interpreter.
To reconnect the PC to the network, reset the Internet Protocol Properties to Obtain an IP
address automatically.
4-6