ElmoMC Multi-Axis Motion Controller-Maestro Installation Guide - Manual (Page 25)

Maestro Installation Guide Installation
MAN-MASIG (Ver 1.33)
3-15
Maestro
Power Supply
Figure 3-7: Power Supply (24v) Connection Diagram
3.7 Powering Up
After the Maestro has been mounted, check that the cables are intact. The Maestro is then
ready to be powered up.
3.8 Initializing the System
After the Maestro has been connected and mounted, the system must be set up and
initialized. The minimum system requirements for a setup are:
• Maestro (and power supply)
• PC (with Elmo Studio and Composer)
• At least one Drive and Motor
• Terminated CAN network
Setting up the drives and motors is described in the Simpliq Servo Drive Installation Guide and
Composer User's Guide. Advanced features are described in the SimplIQ Software Manual,
Interlude API User Guide, SimplIQ Command Reference and CANopen Implementation Guide.