ElmoMC Multi-Axis Motion Controller-Maestro Installation Guide - Manual (Page 18)

Maestro Installation Guide Installation
MAN-MASIG (Ver 1.33)
3-8
3.4.2 Ethernet
Notes for connecting the Ethernet communication cable:
ƒ Use a shielded Cat 5 FTP Ethernet cable.
One of two types of Ethernet cables may be needed depending on your setup:
• standard cable (used for connecting the Maestro to a PC through a hub, switch or router)
• cross cable (used for connecting a PC to the Maestro)
Ethernet Hub/Switch/Router
Std. Eth. Cable
Eth. Cro
ss Cabl
e
Figure 3-2: Maestro Connected to a Network Figure 3-3: Maestro Connected Peer-to-Peer to PC
Pin Signal Signal Pin Pin Location
1 TX+ TX+ 1
2 TX- TX- 2
3 RX+ RX+ 3
4 — — 4
5 — — 5
6 RX- RX- 6
7 — — 7
8 — — 8
Table 3-4: Standard Ethernet Cable - Pin Assignments
Pin Signal Signal Pin Pin Location
1 TX+ RX+ 3
2 TX- RX- 6
3 RX+ TX+ 1
6 RX- TX- 2
4,5,
7,8
— — 4,5,
7,8
Table 3-5: Ethernet Cross Cable - Pin Assignments